ToolReg In-Line Regulator

This innovative and rather unique In-Line regulator ensures a constant pressure is always maintained, despite normal pressure fluctuations in a compressed air system. Mounted directly on the pneumatic tool of choice, this regulator will ensure correct pressure so that potential pressure drops in hoses (or tubes) does not influence the pressure on the tool itself.

When used in a 'blow down' application, this regulator ensures the operator doesn't waste excess air pressure by blowing down at full compressor flow (is 100PSIG), and in the cases where a low pressure is necessary to avoid damage to surrounding areas and ensure safe operation, this regulator controls flow at the preset pressure. Lowering operational costs for the compressor equipment and ensuring a safe work environment.

Residual pressure in the tool is relieved when it is removed from the compressed air supply line, preventing unintentional actuation of the tool.

  • Compressed Air and Neutral gases
  • Lightweight Aluminum Housing
  • SS & Brass Internals
  • 1/4, 3/8, 1/2 & 3/4 sizes
  • Preset PSI ranges from 30 - 120 PSIG
  • -32°F - 176°F temp range


  • ← view all posts